DRIVING & SAFETY - 2
CAYMAN 2007
22
Tow Plug Connection:
The motorhome is pre-wired from the factory
with an electrical connection for towing. The
connection is located on the rear cap, near
the hitch receiver. Convoluted tubing protects
the tow harness wires. Current draw should
not exceed 7.5 amps for each designated light
circuit. Within the electrical connection is a
positive terminal for use when towing a trailer
equipped with a battery. The positive terminal
maintains the charge of the trailer battery.
When preparing a tow plug connection, strip
the wires 3/8". Twist the wire strands and place
under the clip and secure the screw. Make sure
there are no loose strands of wire that could short
against the case or other terminals.
DO NOT
accidentally mirror image the trailer connection.
CAUTION:
Positive terminal connection of the tow
plug remains live at all times. When
towing a trailer equipped with a battery,
unplug the electrical tow connection
when parked. Failure to unplug the tow
connection may result in discharged
chassis batteries.
To Tow Car or Trailer:
1. Connect a tow car or trailer to the
motorhome with safety chains rated for
the weight being towed.
2. Make the electrical connection and
perform a light check before starting a
trip and at each rest stop.
3. Check the tires frequently. Flat tires
on a towed vehicle cannot be detected
from the motorhome while driving.
A fl at tire is a safety hazard and will
cause extensive damage.
REAR VIEW SYSTEM
The motorhome is equipped with a rear
vision system. This system includes up to
three cameras and a dash mounted monitor.
The cameras are located at the rear and sides
(optional) of the motorhome. The select camera
button on the monitor is used to alternate
camera views.
When the rear view system is on, the camera
view will automatically change to the rear view
when the transmission is placed in reverse. The
camera view will also change when a turn signal
is activated to display the corresponding camera
view. This system may be used while driving in
forward, reverse or when parked.
Monitor Controls
Power Button:
Turn the unit on to allow continuous operation
of the rear vision system when the ignition
key is on.
Camera Select:
Press this button to change camera views.
Day/Night:
Change settings for daylight or nighttime
driving conditions
Contrast/Brightness:
Adjusts picture.
Volume:
Adjusts volume.
Tilt Up/Down:
Adjusts rear camera angle. Optional side
cameras are not adjustable.
INFORMATION:
For more detailed instructions,
consult the OEM manual or visit
the manufacturer’s website at www.
asaelectronics.com.
080462f
020078b
Dash Mounted Monitor
Summary of Contents for CAYMAN 2007
