50
English
2) In the selection window, click the process desired and con-
firm with “OK”. When “Shutdown” or “Reboot” has been
selected, an authentication window will appear.
admin
Authentication
Cancel
Authenticate
Password
User
Show Password
Fig. 7-22
Authentication window
3) Enter the password and click “Authenticate”. If the pass-
word feature for the user has not been enabled, you can
click “Authenticate” without having to enter your pass-
word.
4) When “Shutdown” has been selected, the following mes-
sage will appear:
Warning!
Recording was stopped successfully, you can turn off the power
safely now !
Fig. 7-23
Message to inform the user that the recorder can be
switched off
5) Switch off the recorder with the rocker switch (14) on the
rear.
8 Insertions and Error Messages
Insertion
Meaning
?
No hard disk inserted (
☞
chapter 5.1)
Hard disk does not work correctly
!
Hard disk not formatted (
☞
chapter 7.9)
Hard disk write-protected
Hard disk full
To change the overwrite mode so that the oldest
recordings can be overwritten:
In the disk manager (Fig. 7-16), change the setting
“Overwrite” (e. g. from “OFF” to “Auto” or a lower
number of days)
No Camera
This channel does not have any signal
•
The camera image is being recorded
An alarm has been triggered via one of the alarm
inputs SENSOR (12) or ALARM IN (17)
A motion has been detected in the camera image
S
The intelligent analysis feature has detected a specific
situation in the camera image (chapter 6.6.10)
