15
English
5.2 Menu section TX (transmitter)
The menu section TX is indicated by
Use
the button SET to select the menu item desired
5.2.1 Activating / Deactivating the attenuation
for the microphone input
indication
When a pocket transmitter is used for signal
transmission, the microphone input of the pocket
transmitter can be attenuated by 20 dB (if the
microphone level is too high even though the
sensitivity has been set to a low value) This menu
item is without any function when a wireless
hand-held microphone is used
To be selected with the button
:
attenuation activated
To be selected with the button
:
attenuation deactivated
Press the button SET to save the setting
5.2.2 Adjusting the audio sensitivity
indication
The audio sensitivity of the transmitter can be
adjusted in steps of 3 dB from −15 dB to +15 dB
(factory setting: 0 dB) Use the button
or
to
adjust the sensitivity in such a way that an opti-
mum volume level of the transmitter is obtained:
When the volume is too high, the audio signal
will distort; in this case, adjust a lower value
When the volume is too low, there will be a
poor signal-to-noise ratio; in this case, adjust
a higher value
Press the button SET to save the setting
5.2.3 Activating automatic switch-off
indication
The transmitter can be set in such a way that it
will, when muted, automatically switch off after a
specific time The following settings are available:
no automatic switch-off
automatic switch-off after 1 minute
automatic switch-off after 10 minutes
automatic switch-off after 30 minutes
The switch-off time is factory-set to 10 minutes
To change the value, use the button
or
; to
save the changed value, press the button SET
5.2.4 Adjusting the transmission power
indication
Two settings are available for the transmission
power of the transmitter The lower transmission
power will result in a lower power consumption
and thus in a longer battery life; the transmission
range, however, will be shorter
To be selected with the button
:
transmission power of 50 mW
To be selected with the button
:
transmission power of 10 mW
Press the button SET to save the setting
5.2.5 Configuring the REMOSET function
The settings to be transferred by the function
to the transmitter can be defined
To be selected with the button
:
radio frequency (as adjusted on the
receiver), 20 dB attenuation (for a
pocket transmitter), audio sensitiv-
ity, automatic switch-off, transmis-
sion power
To be selected with the button
:
only radio frequency (as adjusted on
the receiver)
Press the button SET to save the setting
6 Adjusting the Volume
Use the button
or
(6) to increase or reduce
the volume (
VOL.
in the lower right corner of
the display) The adjustment range is −31 0 dB
(factory setting: −10 dB)
7 Activating / Deactivating the Key Lock
The button
(4) can be used to lock the but-
tons
(3),
,
(6) and SET (7) When
the key lock is activated, the symbol will be
shown on the display
To activate the lock, keep the button
pressed
until
is briefly shown on the display
To deactivate the lock, keep the button
pressed until
is briefly shown on the dis-
play
