Monark Ergomedic 828 E
9
Ser
vice
1
2
Fig: Batteries
1) Batteries
2) km/mile
Batteries
The batteries are in a separate package at deli-
very. The batteries may need to be replaced upon
assembly. To replace the batteries at any time,
take the meter out of the housing by bending up
in the lower end with a coin or similar. The bat-
teries, 2 x 1.5V size AA(R6), which are placed in
the holder on the backside of the meter, can then
easily be changed. See
fig: Batteries.
After the batteries has been replaced all segments
in the display are visible and a buzzer will sound
for two seconds. After 2 seconds the meter turns
to main display again and normal function. Put
the meter into the housing again.
Note: On the backside of the meter is a switch to
change meter function from km to mile or mile
to km(2).
1
2
3
Fig: Brake belt
1) Tension lever
2) Lock washer
3) Clip
Replacement of brake belt
Remove the tension lever(1). Dismantle the front
cover over the pendulum weight by detaching the
4 screws underneath. Remove the left or the right
frame cover by undoing the mounting screws
(5pcs). Put the crank in a backward position.
Move the cover somewhat out in the front end
and then pull it backwards to remove it. Loosen
the brake belt from the pendulum at the screw
and lock washer(2). See
fig: Brake belt.
Take it apart at the spring and clip(3) and remove
it from the bike. Attach the new brake belt and
assemble the bike in reverse order. Adjust the
brake belt so that the resistance increases as soon
as the tension device is turned a little.
When replacing the brake belt it is recommen-
ded to clean the brake surface. See section ”Brake
belt contact surface”.
Summary of Contents for 828E
