15
REPLACEMENT OF THE FREEWHEELING SPROCKET
Remove left and right frame cover.
Dismantle the chain as described on page 14.
Loosen the axle nuts and lift off the flywheel. Remove the axle nut, washer, chain adjuster and spacer on the
freewheel side. Place the special remover (part No. 9100-14) in the adapter and place the spacer and axle nut
outside. See fig 17.
NOTE: Do not tighten the axle nut completely. It must be possible to loosen the adapter-sprocket half a turn.
Replace sprocket-adapter and assemble the new parts in reverse order according to the above.
LUBRICATION SPROCKET
The sprocket should be lubricated with a few drops of oil once a year. Incline the cycle somewhat to make it ea-
sier for the oil to reach the bearing. See fig 18.
CRANK BEARING
The crank bearing is long term greased and needs normally no supplementary lubrication. If problem arises,
please contact your Monark dealer.
FLYWHEEL BEARING
The bearings in the flywheel are lifetime greased and require normally no maintenance. If problem arises, plea
-
se contact your Monark dealer.
Fig. 17
Fig. 18
