5
Pedal marked R (Right) is to be assembled
on the right hand side of the cycle (the chain
wheel side). The pedal axle has a right hand
thread and must be threaded onto the crank
clockwise. Tighten firmly. See fig 6.
Pedal marked L (Left) is to be assembled on
the left hand side of the cycle. The pedal axle
has a left hand thread and must be threaded
onto the crank counter clockwise. Tighten
firmly. See fig 6.
NOTE! Check now and then that both pedals
are still firmly tightened. If not the threading
in the pedal arms will be damaged.
Also check that the pedal arms are firmly
tightened on the crank axle. If nessecary
tighten.
Fig. 6
Fig. 7
Unscrew the two lower nuts holding the tension
device frame.
Put on the weight holder as in fig. 7.
Screw on and tighten firmly the two nuts again.
