Mondial Designs Limited HB095 2008, Owner'S Handbook Manual

connecting services

28

connecting services

29

2.   Before winter storage the water system 

must be completely drained and the filter 
cartridge removed. Also recharge the 
pump assembly or the blanking plug. 
If you use the Truma external shower 
(optional) and have therefore installed the 
‘connector’, please drain the filter housing 
by connecting up the outside shower and 
allowing the remaining water to drain via 
the open shower head. The filter hole may 
be sealed with the filter cap.

3.   Clean the water system at the start and 

end of the season with sterilising fluid (see 

notes under sterilising).

Sterilising 

1.   When cleaning the water system at the 

start or end of the season It is advisable to 

use a sterilising fluid, e.g. Chempro SDP 

or similar. It is recommended that for this 

operation the filter is removed as the fluid 

reduces the effectiveness of a new filter.

2.   Flush the system thoroughly to remove the 

effective fluid traces.

3.   After sterilising the system at the start of 

the season it is recommended that a new 

Ultraflow filter cartridge should be fitted.

How to prepare your water system for  
winter use

During winter caravanning it is recommended 
to keep the water container within the caravan 

to prevent freezing.

This can be achieved by fitting an Ultraflow 

Compact Housing Unit inside the caravan in a 
location where it is convenient to store a container. 
e.g. the washroom or under the sink etc.
The blanking plug (Fig 5) must be fitted to blank 
off the unused Compact or Filter system.

fig. 5

Special instructions are supplied with the 

Ultraflow winter kit.

During the winter when the caravan or motor 
home is not in use, it is advisable to remove 
the filter to avoid any retained water within the 
filter freezing.
Winter Conversion Kit (white).  

Part No. 46060-01).

Winter Conversion Kit (ivory).  

Part No. 46060-02.

accessories
ultraflow water pump assembly

The Water Pump Assembly comes complete 
with the water pump, container cover and 
storage clip. The submersible pump needs no 
priming and is extremely quiet in operation. 

This pump can be used with both the Ultraflow 
Filter Housing and Ultraflow Compact Housing.

fig. 6

Standard pump assembly (hose length 800mm). 

Part No. 46040-01.

Special version for motor caravans (hose length 

l000mm). Part No. 46040-10.

water SyStem

General 

The motorhome is fitted with a fresh water 
supply system and a waste water system. All 

water hose used in the system is flexible non-

toxic food quality hose and all plastic parts in the 
system conform to Directive 9O/128/EEC.
Fresh water tanks are located under  

vehicle floor.

Water level indicator display is on the digital 
electrical control panel located adjacent to 
the habitation door. The fresh water is moved 

through the system by Shurflo RV fresh 

water pump.

waste tank 

The waste water tank is fitted underneath 
the vehicle, just behind the rear wheels and 
incorporates a drain tap and inspection cap.

water Level Indicator 

The water level indicator digital display 
is mounted on the panel adjacent to the 
habitation door.

filling the fresh water tank 

Fill the tank through the exterior filler cap 

identified with the FRESH WATER transfer. 
Water flowing from the overflow pipe indicates 

a full tank.

Note: A waterline hose or a Thames 

submersible pump can be used to fill the tank.

truma ultraflow filter housing
operating Instructions 
Raise the lid, clean both the water socket and 

the plug of the pump assembly.
Plug the pump assembly into the socket (Fig 1).

fig. 1

fig. 2

Place the pump into the water container (Fig 
2), ensuring that it is fully submerged before 
operating the system. The dust cover (7) is to 
stop contaminates falling into the water container.
To remove the pump assembly from the 

Ultraflow Filter Housing, pull the lower trigger 

and pull out the hose plug.

warnInG: do not remove by pulling the 
hose or electric cable.

routine maintenance 

1.   Ensure that the O-ring seal on the hose 

plug and socket are free from dirt.

2.   To aid fitting of the plug assembly smear 

the O-ring with vegetable oil.

3.   To change the filter, turn the filter cap anti-

clockwise and pull out the filter (Fig 3).

fig. 3

fig. 4

4.   After installation, please drain off the first 

Litres until the filtrate is clear.

Maximum filtering efficiency (cleaning effect) 

can only be achieved if the filter is changed at 
regular intervals. The filter must be changed 
within 35 days of initial use, even if it was 
not in use during this time. Please remember 
that water is a foodstuff. We recommend that 
filtered water is consumed within 1-2 days 
and advise you to drain the system after long 
periods of disuse.
Use dial on the filter housing (Fig 4) for guidance 
to replace after approx. 35 days of use.

notes: 
1.   Never allow the pump to run dry. 

Always ensure that the pump is submerged 
In the water or the lifetime of the pump will 
be reduced.