Mondial Designs Limited HB095 2008, Owner'S Handbook Manual

equipment details

54

equipment details

55

water flows freely from the tap.

note: If only the cold water system is being 
used, the heater tank will also fill with water. 
In order to avoid damage through frost, the 
water heater must be drained as detailed in 
the following paragraph.
draining the water heater

warnInG: the water may be hot and  
cause scalding.

1.   Disconnect the water pump and switch off 

power supply where appropriate.

2.  Open all hot and cold water taps.
3.   Open safety/drain valve and leave in 

vertical position, position (f).

4.   The water heater will drain directly to the 

outside. Check that the water contents 
have been completely drained (10 litres).

GaS operatInG InStructIonS
attention: do not operate the water heater 
without water in it!
Remove the cowl cover prior to using the 

water heater.

Switching on:
1.  Remove cowl cover.

2.   Open gas cylinder and open quick-acting 

valve in the gas supply line.

3.   Select required water temperature with the 

inner rotary knob (b) (infinitely variable from 
approx. 30ºC to 70ºC).

4.   Switch on water heater by turning outer 

rotary control (a) to the flame symbol. A 

green indicator light will illuminate.

fig. 2

5.   If there is air in the gas supply line, it may 

take up to a minute before the gas is 
available for combustion. If the appliance 
switches to ‘Failure’ during this period. 
switch off the appliance - wait 5 minutes - 
and switch on again!

Switching off:

Turn the outer rotary control (a) to 0.
Drain the water heater if there is risk of frost!
If the heater is not to be used for a long period, 
the cowl cover must be fitted to ensure that 
the appliance function is not impaired by the 

ingress of water, dirt or insects. Failure to fit the 
cowl may invalidate the warranty.
Turn off the gas supply at the cylinder.

eLectrIcaL operatInG InStructIonS

attention: do not operate the water heater 
without water in it!

Press the switch on the fused spur to ON. 

The indicator lamp indicates that the heater is 
switched on.

note: under electrical operation, the water 
temperature cannot be selected. the 
temperature is automatically limited to 70ºc. 
for faster heating up period the appliance 
can be simultaneously operated with gas.

fig. 3

maintenance 

The water heater should be serviced annually 
during the routine vehicle service.

The instructions covering fitted equipment to 
your vehicle were correct at the time of going 
to print. Owners handbooks are updated 
annually and we take great care to try and 
ensure their accuracy. However, the Swift 
Group Limited cannot accept responsibility 
for any changes that may be made in 
specification or operating instructions to the 
equipment described in this section after the 
time of going to press.
Every care is taken to ensure that the 
information provided in this handbook is 
correct and easy to understand.

Separate manufacturers’ leaflets on many 

of the components are also included in the 
Owner’s Pack provided with this vehicle 
and we recommend that you compare 
the instructions in the handbook with 
the component manufacturers literature, 
to ensure the information provided is as 
accurate as possible.
If you are in any doubt as to how to operate 
the equipment in your vehicle, please contact 
the component manufacturer’s service 
department on the telephone number shown 

on their component leaflet. If you remain in 

any doubt, please contact the Swift Group 
Supercare customer care service department 
on 01482 875740.

equipment Specification 

For details on type of equipment fitted in  

your vehicle, please refer to the Sales Brochure 

or Dealer.

Important 

To maximise the use and life of all fitted 
equipment in your vehicle it is essential that 
any accompanying manufacturers’ literature is 
read fully. All recommended maintenance and 
preparation procedures should be followed.  
The information provided in this handbook is 
only intended as a guide. If in any doubt consult 
your manufacturer appointed dealer, particularly 
before attempting to install  

EXTRA EQUIPMENT.

NOTICE: In the interest of safety, 

replacement parts for an appliance shall 
conform to the appliance manufacturer’s 
specifications and should be fitted by them 
or their authorised agent.

truma uLtra-Store  
water Heater

the water heater features a system that 
will heat water using liquid petroleum gas 
or 230v mains electricity. the heater can 
be simultaneously operated on gas and 

electricity to give a faster warm-up period. 
the cassette has a capacity of 10 Iitres.

attention: always fit the cowl cap when 
the water heater is not being operated! 
drain the water heater if there is risk of 
frost and preferably when you leave the 
site. Leave all taps open. frost damage is 
not covered by the warranty!

filling the truma-ultrastore with water

1.   Check that the safety/drain valve in the cold 

water intake is closed. Lever should be in 
horizontal position, position (e) Fig. 1.

fig. 1

e =  Lever position 

‘closed’

f =  Lever position 

‘drain’

2.   Open hot tap in bathroom or kitchen; set 

pre-selecting mixing taps or single lever 
fittings to ‘hot’.

3.   Switch on power for water pump. Leave the 

tap open to let air escape while the water 
heater is filling. The heater is full when