Mondial Designs Limited HB095 2008, Owner'S Handbook Manual

equipment details

56

equipment details

57

trumatIc e2400

trumatic e 2400 L.p.G. Heater with 
electronic control, built-in air distribution 
and thermostat

operating instructions

Always observe the operating instructions and 
‘Important operating notes’ prior to starting! 
The vehicle owner is responsible for the correct 
operation of the appliance!
The installer or vehicle owner must apply the 
yellow sticker with the warning information, 
which is enclosed with the appliance, to a place 
in the vehicle where it is clearly visible to all 
users (e.g. on the wardrobe door)! Ask Truma to 
send you stickers, if necessary.

control panel with sliding switch

a   Slide valve 

Heating – Off – Ventilation

b   Slide valve for high setting (large flame 

symbol) and low setting (small flame symbol)

control panel with rotary switch

c   ‘Heating’ rotary switch high setting  

(large flame symbol) and low setting 

(small flame symbol)

d   ‘Off’ rotary switch

e   ‘Ventilation’ rotary switch high setting (large 

symbol) low setting (small symbol)

Switching on the Heating
1.  Remove cowl cap.

2.   Turn on gas cylinder and open quick-acting 

valve in the gas supply line.

3.   Adjust desired room temperature at  

rotary knob.

4.  Switching the heating on: 

control panel with sliding switch: 

Set the switch (a) to Heating and switch (b) to 
the desired output setting.

control panel with rotary switch: 

Set the rotary switch to the desired output 
setting (c). If the outside temperature is low, 
switch to high setting.
The Trumatic E heater has been tested and 
approved for operation, also when the vehicle 
is moving. The burner with fan assistance 
guarantees satisfactory operation, even 
under extremely windy conditions. It may be 
necessary to observe respective, country-
specific regulations for the operation of liquid 
gas appliances when the vehicle is moving.

Switching on the ventilation
control panel with sliding switch: 
Set switch (a) to Ventilation and switch (b) to 

the desired output setting.

control panel with rotary switch: 

Set the rotary switch to the desired output 
setting (e).

Switching off

repairs 
Repairs should only be carried out by qualified 

personnel, as otherwise the warranty will be 
void. Only original Truma parts are to be used.

de-scaling 

Introduce wine vinegar into the water system 
and allow time for it to react with the scale. 
Flush out thoroughly with fresh water.

Hygiene 

The water tank in the water heater Is made of 
high quality stainless steel. However. to avoid 
micro-organism colonization of the tank, it 
should be heated to 70ºC with the electrical 
heater at regular intervals. Do not drink water 
from the hot taps.

fuses 

The water heater fuse is on the electronic 
control unit on the water heater.

note: only replace the miniature fuse on 
the p.c.b. with a fuse of the same type: 
1.25 at en 60127-2-3 (slow action).

General safety notes 

If the gas system is leaking or if there is a  
smell of gas:

•  Extinguish all naked flames.
•  Do not smoke.
•  Switch off the appliances.

•  Shut off the gas cylinder.
•  Open the windows.
•  Do not actuate any electrical switches.
•   Have the entire system checked by an expert.
1.   Repairs may only be carried out by an expert.

2.   The following will invalidate the guarantee:
 

a)   Any alteration to the appliance. 

including the cowl.

b)   The use of non-original Truma  

parts/accessories.

c)   Non-observance of the 

Operating Instructions.

3.   The operating pressure for the gas supply 

is 30 mbar and must correspond to the 
operating pressure of the appliance (see 
data plate).

Liquid gas systems must comply with the 
technical and administrative regulations of 
the respective country of use (e.g. en 1949 
for vehicles in europe).
a qualified technician must inspect/test 
according to en 1949 every two years and a 
certificate issued.

The vehicle owner is always responsible for 
arranging the inspection.
4.   Do not operate the water heater when 

refuelling the vehicle and when in the garage.

5.   During the initial operation of a brand new 

appliance (or after it has not been used for 
some time), a slight amount of fumes and 
a certain smell may be noticed for a short 

while. Remedial action is to immediately 

run the heater at maximum output and to 
ensure adequate room ventilation.

6.   If the burner makes an unusual noise or if the 

flame lifts off, it is likely that the regulator is 

faulty and it is essential to have it checked.

technical data
water contents: 

10 Iitres

water pressure: 

up to max. 2.8 bar

type of gas: 

Liquid gas (propane/butane)

operating pressure: 

30 m/b

rated thermal output: 

1500 W

Gas consumption: 

120 g/h

Heating time up to approx. 70ºc: 

Gas operation: approx. 35 minutes 
Electrical operation: approx. 70 minutes 
Gas and electrical operation: approx 20 minutes.

power consumption 12 v 

Ignition: 0.17 A 
Heating up: 0.08 A 
Standby: 0.04 A

power consumption 230 v 

Heating up: (2 A) 450 W 
Weight (empty): Approx: 6.7 kg