Mondial Designs Limited HB095 2008, Owner'S Handbook Manual

equipment details

90

equipment details

91

operations using the reverse sequence.

 Check possible gas leaks by means of a 
soapy solution as described above.

5.   Ignite burners and check correct operation 

of the same; in case of negative result, 
contact an authorised technician

vISuaL fLame controL
1.   The flame is right, when its internal tongue 

is blue and its outline well-defined.

2.   If the flames have yellow tips and little 

pressure, consult your dealer.

eLectrIcIty SuppLy
The electricity supply is 12 Volts direct 

current (D.C.).

use the appliance only in a well  
ventilated space

The ventilation openings must remain open 
when the appliance are operating.

Ignition of the appliance
manual Ignition: oven - Grill

1.   Push in control knob slightly, turn to ignition 

position. Light burner with match or lighter 
keeping knob pushed in for 5-10 seconds.

2.   Release knob and turn it to 

required position.

automatic Ignition: oven - Grill

1.   For igniting oven or grill, open oven  

door completely.

2.   Push in control knob slightly, turn to  

ignition position keeping it pushed in for 
5-10 seconds.

3.   Release knob and turn to required position.
note: 

Oven and grill burners will not light if the 

door is not completely open.

Ignition of appliance with thermostat

Proceed as above, with or without electronic 
ignition. The ignition position is obtained by 
turning the control knob to a position between 
1 and 6 for the oven and grill position (see 
symbol 

▲▲▲▲

)

For ovens with the thermostat, the different 
positions of the knob correspond to the 
following temperatures in ºC of the oven:
Position. 

1 

2 

3 

4 

5 

6 

Temperature. 130  160  180  200  220  240

Important: 

If ignition is unsuccessful, repeat 

operation from the beginning; if necessary 
have the appliance checked for a gas and/or 
electricity failure in the appliance. If appliance 

absolutely does not work, close gas tap inlet and 

contact retailer. Before using oven for the first 

time, let it run at maximum temperature for the 

duration of ½ hour, without foodstuffs inside.

Use oven gloves when handling hot elements.

In the event of the burner flames being 

accidentally extinguished, turn off the burner 
control and do not attempt to re-ignite the 
burner for at least 1 minute.
This appliance is designed to cook foods only. 
Any other use is considered incorrect and 
dangerous. The manufacturer is not responsible 
for any damage to persons or parts due to 
incorrect installation, improper, incorrect, or 
irresponsible use.

this appliance must be installed in 
accordance with regulations in force and 
only used in a well-ventilated space. read 
the instructions before installing or using 
this appliance. the appliance must be 
installed by specialist technicians.
SMEV hotplate units operate with the following 

gases and corresponding supply pressures. 
The category (or categories) according to 
which the appliance has been adjusted is 
clearly indicated on the packaging and on 
the data plate attached to the back of the 
appliance. Check this data before connecting 
the appliance to the gas cylinder.
The pressure regulator to be used between the 

Smev oven

Smev oven with grill Instructions

OF311FG & OF311FGT
The ovens, the cookers and the grill 
compartment operate with the following gases 
and corresponding supply pressures.
The category (or categories according to which 
the appliance has been adjusted, is clearly 
indicated on the packaging and on the data 
plate attached to the back of the appliance.
Please check this data before connecting 
appliance to gas cylinder.
The pressure regulator to be used between the 
cylinder and the appliance must comply with 
the categories indicated in the table below.

Category

mbar

Gas

Output of the 
regulator

1 3 (50) 

1 3 (50)

50 

50

G 30 

(Butane)

G 31 
(Propane)

1.5 kg/h 

1.5kg/h

1 3+ 

(28-30/37)
1 3 (30)

1 3+ 

(28-30/37)
1 3 (30)

28-30 

30
37 

30

G 30 

(Butane)

G 31 
(Propane)

1.5 kg/h 

1.5kg/h

attention: the appliance must be installed 
by specialist technicians in accordance 
with current standards.

If operating problems should arise when the 
appliance has been installed, it is advisable to 
contact the retailer.

Important: in order to avoid every 
possible accident, it is essential for 
the appliance to be installed according 
to the descriptions contained in these 
instructions. an incorrect installation 
causes the loss of the guarantee.
any modification of the appliance can  
be dangerous.

GaS cyLInder

The appliance must be connected to a gas 
cylinder that operates at the same working 
pressure that the appliance is designed. Check 
the data plate affixed to the appliance.

the use of a type of gas and/or of a pressure 
different from those prescribed by Smev, 
can cause irregular operating conditions 
of the appliance; for this reason, Smev 
declines any responsibility originating from 
incorrect use of the appliance itself.
observe the following instructions

The gas cylinders must be pieced in the 
comportment assigned to this purpose in a 
vertical position with the valves and pressure 
reducers fitted; the access to the same 
must not be obstructed. It must be possible 
to replace the cylinders easily and without 
obstacles. After use, shut off gas supply from 
the cylinder

when replacing the gas cylinder, the 
following precautions shall be taken

1.  Close taps of the appliance (pos. O);

2.   Make sure there are no flames or fires lit in 

the proximity;

3.   Close valve of cylinder to be replaced; 
4.   Screw off regulator of empty cylinder, take 

it out of the comportment assigned for 
this purpose. For replacement carry out