equipment details
100
equipment details
101
6. Adjust them to the required height. The
fabric can be tightened by rolling up a little.
6
never put out the support arms that high,
that the fabric jams between the arms and
the box.
7. Fasten the support arms.
fig. 7
8. Install the tension rafter (for 3.75 m awning).
8
9. When raining, lower one side of the awning
in such a way that the water can run down
the fabric. Prevent the fabric from flying up
by a sudden wind blow by using the hold
down kit (optional).
9
omnIStor awnInG
General remarks:
- An awning is a sun and not a rain protection.
The awning should be in closed position in
case of storm, snowfall or heavy rainfall.
- The awning can not be used without putting
out the support arms.
- The fabric may not be rolled up wet for a
longer period.
- Clean the awning only by using water or
OMNI CLEANER.
users instructions:
1. Adjust the crank to the required height.
1
2. Introduce the crank arm into the
bayonet joint.
2
3. Unroll the awning while keeping the crank
down. The awning will only open after a
couple of turnings.
3
4. Unroll till 1 m max. Then put out the
support arms before further unrolling
4
5. Slide the support arms out of the
front profile.
5
Summary of Contents for HB095 2008
