71D0532
21
LOG PLACEMENT
Figure 19 - Installing Rear Log (#1)
Before you begin
— This unit is supplied with six (6) ceramic fiber logs. Do not handle these logs with your bare hands.
Always wear gloves to prevent skin irritation from ceramic fibers.
After handling the logs, wash your hands gently with
soap and water to remove any traces of fibers.
INSTALLING CHARRED TIMBER LOGS ON
BURNER
W
ARNING
The positioning of the logs is critical to the safe and clean operation of this heater. Sooting
and other problems may result if the logs are not properly and fi rmly positioned in the
appliance. Never add additional logs or embellishments such as pine cones, vermiculite or
rock wool to the heater. Only use the logs and EB-RW (rock wool) supplied with the unit.
Failure to position the parts in accordance with diagrams below or to use only parts
specifi cally approved for this heater may result in property damage or personal injury.
Figure 20 - Installing Right Base
Log (#2)
Pins
Rear Log (#1)
1. Place rear log (#1) on two
located pins on the back of
the grate.
See Figure 19.
2. Place right base log (#2) on two
pins on right side of grate.
See Figure 20.
Pins
Right Base Log (#2)
Summary of Contents for DFS32NVC
Page 43: ...71D0532 43 NOTES ...
