Monessen Hearth Systems
P/N 33D1105 Rev. 1 • January 2000
Left Trim
Top Trim
Right Trim
#6 Screw
6. Lay out two side trim pieces and one top trim piece on flat surface as shown in
Figure 2
. Use caution not to scratch brass
trim.
Note: Top trim piece is mitered (cut 45
°
angle) on both ends.
7. Separate trim sides from top piece enough to insert miter clamps and miter clamp backing plates.
See Figure 3
. Make
certain screw heads are visible. Rejoin edges of trim pieces. Carefully tighten down screws while maintaining a good fit
at the trim joints.
See Figure 4
. Do not over tighten screws.
8. Place assembled trim unit over top and sides of fireplace insert flush with front surface.
See Figure 5
. Align holes in trim
unit with holes in fireplace. Insert #6 screw into each hole and tighten snugly.
See Figure 5
.
9. Connect fireplace to gas supply as instructed in Owner’s Manual. Installation and service must be performed by a quali-
fied installer, service agency, or the gas supplier. Power cord can be routed to left or right side.
See Owner's Manual.
Figure 2 - Laying Out the Trim Pieces
Miter Clamp
Miter Clamp
Backing Plate
Figure 3 - Inserting Miter Clamps
Figure 4 - Rejoining Trim Pieces and
Tightening Screws
Screws
Trim
Plate
Figure 5 - Installing Trim
#6
Screw
Screw Head
Assembled
Trim Unit
