1. Read these instructions entirely before beginning any part of the installation. Save these instructions for
any future repairs.
2. Use these instructions as a guide during the installation of the fireplace.
3. Be sure these instructions become the property of and are reviewed by all future users of this fireplace to
encourage proper operation and maintenance.
4. All the parts used with this fireplace system must be installed in accordance with these installation instructions.
Failure to do so may be hazardous and will void the warranty.
5. This fireplace and accessories should not be altered in any way that is not specifically recommended in
this manual.
6. Refer to your local building code for local requirements pertaining to installation of factory-built fireplaces.
These fireplaces are intended for installation and use according to standard NFPA NO.211 of the National
Fire Protection Association.
7. This fireplace must not be installed with a masonry flue.
8. This fireplace and chimney should not be used for venting a wood or coal burning heater or fireplace insert.
Warning: Do not install a separate solid fuel insert or gas fireplace insert into this fireplace and chimney
system without written authorization.
9. Warning: Do not pack required air spaces with combustible material or insulation not specifically
recommended for use in such areas.
I
NTENDED
P
RODUCT
U
SAGE
The fireplace is designed to sit directly on a combustible floor. The fireplace must be installed with clearances
to combustible building materials specified in this manual. Only parts manufactured by Monessen Hearth
Systems and labeled for use with the fireplace should be used in the installation of this fireplace except for
special roof flashings that may be fabricated locally. The use of improper parts in the installation can be
hazardous and voids the warranty offered by Monessen Hearth Systems.
This fireplace is designed to burn wood. This fireplace is not designed to burn coal, unplumbed liquid fuels,
unplumbed gaseous fuels or household refuse. Any attempt to burn these fuels in the fireplace can be hazardous.
Failure to heed usuage warnings may cause a fire hazard and will void the Warranty. This fireplace is intended
for supplemental heating only and is not intended for use as a primary heating system. For use with Solid
Wood Fuel, UL Classified Processed Solid Fuel Fire Logs, or Certified Decorative Gas Appliance.
“Do not use a fireplace insert or other product not specified for use with this fireplace.”
I
MPROPER
I
NSTALLATION
Improper installation or use of this fireplace will void the warranty and can cause:
1. Damage to the fireplace from overheating.
2. Hazardous temperatures to develop on combustible materials adjacent to the fireplace or chimney.
3. The emission of smoke, sparks or hazardous gases into the dwelling.
4. Leakage of rain water into the dwelling.
2
2
I
MPORTANT
I
NFORMATION
53D9035. Rev 1 03/03
Summary of Contents for HWB600
