12
32D1999
Figure 10 - VDY30D Log Placement
1
2
3
4
5
6
7
LOG PLACEMENT
DUZY 24 (VDY24/18D) LOG INSTALLATION SEQUENCE:
1. Install the rear log (#1) on the two locating pins. Visually check
to verify the log is securely placed on the pins and in contact with
the grate.
See Figure 9.
2. Install the right log (#2) on top of the control cover. Slide the log back
until touching the rear log (#1). Visually check to verify the log is
resting on the grate and control cover.
See Figure 9.
3. Install the left log (#3) with its bottom groove resting on the right
side of the grate bar. Slide the log back until touching the rear log
(#1). Visually check to verify the log is resting on the grate.
See
Figure 9.
4. Install the top right log (#4) with the two branches resting on the two
grate fingers in the front and the back resting on the pad of the rear
log (#1). Visually check to verify the log is resting on its notches with
the grate and rear log.
See Figure 9.
5. Install the top left log (#5) with the branch resting on the remaining
front grate finger and the two branches resting on the pads of the rear
log (#1).
See Figure 9.
DUZY 30 LOG (VDY30D) INSTALLATION SEQUENCE:
1. Install the rear log (#1) on the two locating pins. Visually check to
verify the log is securely placed on the pins, and in contact with the
grate.
See Figure 10.
2. Install the right log (#2) on top of the control cover. Slide the log back
until touching the rear log (#1). Visually check to verify the log is
resting on the grate and control cover.
See Figure 10.
3. Install the left log (#3) with its bottom groove resting on the right
side of the grate bar. Slide the log back until touching the rear log
(#1). Visually check to verify the log is resting on the grate.
See
Figure 10.
4. Install the top right log (#4) with the back resting on right log (#2)
and the front resting on the burner. Pull the front of the log forward
until it touches the front great finger.
See Figure 10.
5. Install the top left log (#5) with the back resting on left right log (#3)
and the front resting on the burner. Pull the front of the log forward
until it touches the front grate finger.
See Figure 10.
6. Install the top right center log (#6) with the two branches resting on
the two left-hand side front grate finger and back of the log on the
pad of the rear log (#1).
See Figure 10.
7. Install the top left center log (#7) with the branch resting on the front
grate finger and the two branches resting on the pads at the center of
the rear log (#1).
See Figure 10.
LOG PLACEMENT
IMPORTANT:
Remove logs, handling carefully by holding gently at each end. Gloves are recommended to prevent
skin irritation from ceramic fibers. If skin becomes irritated, wash gently with soap and water.
Figure 9 - VDY24/18D Log Placement
4
1
5
3
2
