Compact Hopper Test Box Instructions TSP063doc Issue 2.1 – June 2004
©
Money Controls 2004. All rights reserved.
Page 10 of 11
4.4
PULSE / COUNT
Switch on the power supply.
The display will show the following:-
The left hand side of the display (COUNTER) shows how many coins have been paid out
while the right hand side (CURRENT) shows the current being drawn by the hopper.
Switch “HOPPER / ON” to “ON” to start the hopper paying out coins.
The display will show the following:-
Set the “COUNT” dial to the required number of coins to be paid out.
Press the “OPTO TEST / START COUNT” button.
The display will show:-
As each coin is paid out, the counter will increment by 1, the “OPTO” LED will flash and
the motor will pause for 500ms (
Pulsed Mode
) before starting again and paying out the
next coin
.
The hopper will stop once the preset “COUNT” value has been reached and the display
will show:-
Press the “OPTO TEST / START COUNT” button to repeat the required coin payout.
Note:- Should the opto become blocked while paying out in PULSED mode, the disk
will continue to move around very, very slowly.
