9
1.Step 1
– See Figures 1 to 5:
Connect each tube to the base of the jumper as shown on the figures from 1 to
6. After each attachment you will hear a click. The base must fork the shape of a circle.
2.Step 2
– See Figures 6, 7 and 8:
Take the plastic seat. Turn it so that the star mark is pointed towards you
insert the pins of the seat in the yellow openings of the pad. Pull the pad through the seat frame. Fold its end
around the outer side of the seat frame. Align the other 6 openings with the corresponding pins on the seat.
Insert the pins ion the seat pad openings.
3.Step 3
– See Figure 9:
Press the buttons at the end of the frame tube. Slide the tube inside the opening of the
base tube. Assemble the rest of the frame tubes.
4.Step 4
– See Figure 10:
Attach the seat with the pad to the frame. Press to fix it. You will hear a click. Pull
carefully the seat up in order to make sure it is correctly fixed.
5.Step 5
– See Figure 11: Съвет: Advice:
We recommend you to place the batteries in the electric toy before
placing it on the panel. Attach the rainbow toy to the openings at the base with the tiger toy. Press carefully to fix
it. Attach the toys to the seat panel as shown.
6.Step 6
– See Figure 12:
Place the decorative palm leaves with the hanging toys in the openings intended for
them. Pull them forward to check if they are well fixed.
PLACING OF THE BATTERIES OF THE MUSIC TOY
In order to activate the functions of the music toy, you must place in the battery compartment 3 x 1.5V
“AA” batteries:
1. Loosen the screws of the battery compartment lid with a
Phillips screwdriver and remove it.
2. Place 3 pieces 1.5V
„АА” (LR6) alkaline batteries in the
battery compartment.
3. Put back the lid of the battery compartment and tighten it
with the screws.
4. When the sounds and the lights become weak or they do
not activate at all, you must replace the batteries of the
product, because they are most probably discharged.
5. Only an adult must replace the batteries.
6. If this product starts to stop and go during operation you
must reset the electronics: slide the power/volume switch
and turn it off and then back on.
Information for the safety of the batteries
In case of an emergency liquids may leak from the batteries, which may cause injuries due to chemical burn or
damage of the product. In order to avoid leakage of the batteries:
1.Do not mix discharged/ old with new batteries or of different types: alkaline, standard (carbon
– zinc) or
rechargeable (nickel
– cadmium).
2. Place the batteries correctly according to the polarity, marked on the internal side of the battery compartment.
3. Remove the batteries if you are not going to use the product for a long period of time.
4. Always remove the discharged batteries from the toy.
