[9]
A.
Parameter Modify:
1.
.......................................................................................................................
Crank Settings
1.
Detect Frequency
Setting
：
Disable/ Enable
Default
：
Enable
Description
：
Check frequency value before cranking the engine.
2.
Detect oil press
Setting
：
Disable/ Enable
Default
：
Enable
Description
：
Check oil pressure before cranking the engine.
3.
Crank interval
Setting
：
5~40(seconds)
Default
：
10
Description
：
Set the duration of each crank.
4.
Crank attempts
Setting
：
1~10
Default
：
3
Description
：
Set total number of crank attempts.
5.
Escape up limit
Setting
：
15~30(Hz)
Default
：
20
Description
：
When frequency reaches setting, starter motor disconnects from engine.
6.
Engage low limit
Setting
：
15~30(Hz)
Default
：
20
Description
：
If frequency is below setting allows crank procedure
7.
OP build up time
Setting
：
0.2~2.0(Seconds)
Default
：
0.6
Description
：
Time delay before disconnecting starter motor after oil pressure switch
activates. (“Detect oil press” must be enabled.)
8.
Idle interval
Setting
：
0~600(Seconds)
Default
：
0
Description
：
Duration of engine idle
Summary of Contents for GTR-610
Page 6: ... 6 Dimensions ...
Page 28: ......
