Installation and Operations Manual • 7
REV. 20 MAY 2011
Multi-Door Installation
Two or more doors can be wired to the Monitor 3000 at the same time. The
doors must be wired in series as shown.
Connecting Power Supply to the Monitor
THESE WIRES ARE
FACTORY INSTALLED
DO NOT LOOSEN
UPPER SCREWS
POSITIVE WIRE IS MARKED POS
NEGATIVE WIRE IS MARKED NEG
MAKE SURE ALL SCREW
CONNECTIONS ARE
TIGHT
DOOR SWITCH
2-CONDUCTOR CORD
TO POWER SUPPLY
CONNECTION PANEL
(INSIDE THE ALARM)
Inside The Monitor - Doors are wired in series, One
wire from each door spliced together. The other two
are connected to the screws on the “connection
panel“ labeled “Door Sensor“
FROM THE
TWO DOORS
DOOR #2
FARTHEST FROM MONITOR
DOOR #1
CLOSEST TO MONITOR
TO THE MONITOR
