Operation
Section 3
3-6
Part Number 040003628 08/13
Operational Checks
GENERAL
Your ice machine was factory-operated and adjusted
before shipment. Normally, a newly installed ice machine
does not require any adjustment.
To ensure proper operation, always follow these
Operational Checks when starting the ice machine:
• for the first time
• after a prolonged out of service period
• after cleaning and sanitizing
Routine adjustments and maintenance procedures
outlined in this manual are not covered by the warranty.
ICE CUBE THICKNESS CHECK
The ice cube thickness is factory-set to maintain the ice
cube thickness at the proper size and weight.
1. Allow the ice machine to operate for three complete
cycles. The cubes should have a small dimple in the
center.
2. Cycle times vary, according to surrounding air and
water inlet temperatures.
3. If cubes are not full (large dimple), raise the “dip
switch” level to increase cube size. Allow ice
machine to complete three cycles, then check cube.
4. If cubes are too full, ( no dimple), lower the “dip
switch” level to decrease cube size.Allow ice
machine to operate three complete cycles.
5. The “dip switch” can be adjusted to five levels: -2/-1/
0/
+
1/
+
2, and ensure that only one level switch is
pressed.
CUBE SHAPE
the standard cube has an average weight of 19 grams,
Notice the normal dimple in the center of the cube.
Important
It is recommended that adjustments made to this ice
machine be m ade by a qu
alified te chnician.
Improper adjustment, may seriously affect the life of
this ice machine.
dip switch
Factory
Default
Setting
Decreas
e
Cube
Size
Increase
Cube
Size
Dimple
Standard Cube 19g
33
34
Q_UnderCounter_uc.book Page 6 Sunday, January 26, 2014 3:48 PM
