HOW TO USE
How to customize the operating configuration
(BF-041 Setup Utility Software)
The following operating configurations of the BF-041 can be changed using the BF-041 Setup
Utility Software.
• Auto Power Off Time
If no button is pressed after the power is turned on, the lamp automatically turns off after 120
minutes and the copyboard goes into standby mode. You can change this setting considering
the time of your meetings, for example.
• 30 min. (min)–240 min. (max)
• Default: 120 min.
• Warm-up Time
Longer warm-up time is recommended if you use the copyboard in lower temperature or if dark
lines appear in the horizontal direction on the output image.
• 0 sec. (min)–120 sec. (max)
• Default: 0 sec.
• Brightness
The brightness of the image can be changed depending on the user’s operating environment,
such as the color and condition of markers. The higher the value, the darker the image will be
scanned.
• 70% (min)–90% (max)
• Default: 80%
1. Preparation for installing software
Put the supplied CD-ROM on the optical drive of the computer and install “BF-041 Setup Utility”.
2. Connect the copyboard and a computer using a USB cable, then turn the power
of the copyboard on.
3. Install the dedicated USB driver into your computer.
(It is required only for the first time you use the copyboard with the computer.)
4. Start “BF-041 Setup Utility” then choose the condition you would like to change.
5. Keep the CD-ROM in a safe convenient location, so that it is available to install
drivers on other PCs.
* For a detailed explanation, see Page E-15.
E-10
http://www.monomachines.com/
http://www.monomachines.com/
