Monogram Advantium ZSB912, Owner'S Manual

TROUBLESHOOTING TIPS

FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY INTERFERENCE 
STATEMENT (U.S.A. ONLY)

This equipment generates and uses ISM frequency 

energy and if not installed and used properly, that is in 

strict accordance with the manufacturer’s instructions, 

may cause interference to radio and television reception. 

It has been type tested and found to comply with limits for 

ISM Equipment pursuant to part 18 of FCC Rules, which 

are designed to part 18 of FCC Rules, which are designed 

to provide residential installation.
However, there is no guarantee that interference will not 

occur in a particular installation. If this equipment does 

cause interference to radio or television reception, which 

can be determined by turning the equipment off and on, 

the user is encouraged to try to correct the interference by 

one or more of the following:

Ŷ5HRULHQWWKHUHFHLYLQJDQWHQQDRIWKHUDGLRRUWHOHYLVLRQ
Ŷ5HORFDWHWKH0LFURZDYH2YHQZLWKUHVSHFWWRWKH

receiver.

Ŷ0RYHWKHPLFURZDYHRYHQDZD\IURPWKHUHFHLYHU
Ŷ3OXJWKHPLFURZDYHRYHQLQWRDGLIIHUHQWRXWOHWVRWKDW

the microwave oven and the receiver are on different 

branch codes.

The manufacturer is not responsible for any radio of TV 

interference caused by unauthorized modification to this 

microwave oven. It is the responsibility of the user to 

correct such interference.

Supplier’s Declaration of Conformity

47 CFR § 2.1077 Compliance Information 

Unique Identifier:  Microwave, ZSB912 and ZSB913
Modular Component:  Wireless LAN Module
Modular Component FCC ID:  COF-WMBNBM26A
Responsible Party:      GE Appliances
   Appliance 

Park,

   Louisville, 

KY 

40225

   monogram.com
FCC Compliance Statement: This device complies with 

part 18 of the FCC Rules.
FCC Compliance Statement: This device complies with 

part 15 of the FCC Rules. Operation is subject to the 

following two conditions: (1) This device may not cause 

harmful interference, and (2) this device must accept any 

interference received, including interference that may cause 

undesired operation.

NOTE: 

This equipment has been tested and found 

to comply with the limits for a Class B digital device, 

pursuant to part 15 of the FCC Rules. These limits are 

designed to provide reasonable protection against harmful 

interference in a residential installation. This equipment 

generates, uses and can radiate radio frequency energy 

and, if not installed and used in accordance with the 

instructions, may cause harmful interference to radio 

communications. However, there is no guarantee that 

interference will not occur in a particular installation. If this 

equipment does cause harmful interference to radio or 

television reception, which can be determined by turning 

the equipment off and on, the user is encouraged to try 

to correct the interference by one or more of the following 

measures:

Ŷ5HRULHQWRUUHORFDWHWKHUHFHLYLQJDQWHQQD
Ŷ,QFUHDVHWKHVHSDUDWLRQEHWZHHQWKHHTXLSPHQWDQG

receiver.

Ŷ&RQQHFWWKHHTXLSPHQWLQWRDQRXWOHWRQDFLUFXLW

different from that to which the receiver is connected.

Ŷ&RQVXOWWKHGHDOHURUDQH[SHULHQFHGUDGLR79

technician for help.

To satisfy FCC RF exposure requirements, a separation 

distance of 20 cm or more should be maintained between 

the antenna of this device and persons during device 

operation.
To ensure compliance, operations at closer than this 

distance is not recommended.

WARNING

Any changes or modifications to this unit 

not expressly approved by the party 

responsible for compliance could void the user’s authority 

to operate the equipment.

49-7000077   Rev.0

27