8
Operating Instructions
Stainless Steel Refrigerator
Temperature
controls
The temperature controls are preset in the factory at
37°F
for the fresh food compartment
and
0°F
for the freezer compartment. Allow 24 hours for the temperature to stabilize to the
preset recommended settings.
The temperature controls can display both the
SET
temperature as well as the actual
temperature in the fresh food and freezer compartments. The actual temperature may vary
slightly from the
SET
temperature based on usage and operating environment.
Setting either or both controls to
OFF
stops cooling in both the freezer and fresh food
compartments, but does not shut off electrical power to the refrigerator.
NOTE:
The refrigerator is shipped with protective film covering the temperature controls.
If this film was not removed during installation, remove it now.
To change the temperature,
press and release the
WARMER or COLDER pad. The SET light will
come on and the display will show the set
temperature. To change the temperature, tap
either the WARMER or COLDER pad until the
desired temperature is displayed. Fresh food
temperatures can be adjusted between 34°F and
44°F and the freezer temperatures can be
adjusted between -6°F and +6°F.
Once the desired temperature has been set, the
temperature display will return to the actual fresh
food and freezer temperatures after 5 seconds.
Several adjustments may be required. Each
time you adjust controls, allow 24 hours for the
refrigerator to reach the temperature you have set.
To turn the cooling system off,
tap the WARMER
pad for either the fresh food compartment or the
freezer until the display shows OFF.
To turn the
unit back on,
press the COLDER pad for either
the fresh food compartment or freezer. The SET
light will illuminate on the side you selected. Then
press the COLDER pad again (on the side where
the SET light is illuminated) and it will go to the
preset points of 0°F for the freezer and 37°F for
the fresh food compartment.
The Performance Air-Flow System is designed to
maximize temperature control in the fresh food
and freezer compartments. This unique special
feature consists of the Air Tower along the top
and back walls of the fresh food compartment and
the Air Tunnel on the bottom portion of the
freezer rear wall. Placing food in front of the
louvers on these components will not affect
performance. Although the Air Tower and the
Air Tunnel can be removed, doing so will affect
temperature performance. (For removal
instructions, on-line, 24 hours a day, contact us
at www.monogram.com or call 800.444.1845.
In Canada, call us at 1.888.880.3030.)
Performance
Air Flow
System
