23
31-1000600 Rev. 0
Installation Instructions - Dual Integrated Installation
STEP 6 CONNECTING WATER
SUPPLY
Ŷ
Locate and bring the tubing to the front of the
cabinet.
Ŷ
Turn the water on to flush debris from the line. Run
about a quart of water through the tubing into a
bucket, then shut off the water.
STEP 6 CONNECTING WATER
SUPPLY
Ŷ
Remove strain relief screw to allow for enough slack
to make a proper water connection.
(Screw must be
replaced in the next step.)
Copper Tubing:
Ŷ
Slip a 1/4” nut and ferrule (provided) over both ends
of the copper tubing. Insert the tube into the union
fitting on the unit and tighten the nut to the union.
Ŷ
Turn on the water to check for leaks.
SmartConnect
™
Tubing:
NOTE:
The only GE Appliances-approved plastic tubing
is supplied in the SmartConnect
™
Refrigerator Tubing
kits. Do not use any other plastic water supply line
because the line is under pressure at all times. Other
types of plastic may crack or rupture with age and
cause water damage to your home.
Ŷ
Insert the molded end of the tubing into the
refrigerator or freezer connection. Tighten the
compression nut until it is just hand-tight.
Ŷ
Follow the instructions provided with the tubing.
Overtightening can cause leaks!
Ŷ
Turn on the water to check for leaks.
Freezer
Water Supply
House
Water Supply
Refrigerator/
Freezer
Water Supply
Strain Relief
Screw
WARNING
ELECTRIC SHOCK HAZARD
Attach tubing clamp using existing hole only. DO
NOT drill into the refrigerator.
WARNING
ELECTRIC SHOCK HAZARD
Attach tubing clamp using existing hole only. DO
NOT drill into the refrigerator.
AVERTISSEMENT
RISQUE DE DÉCHARGE
ÉLECTRIQUE
Fixez le collier de serrage dans le trou présent seulement.
NE PERCEZ PAS dans le réfrigérateur.
AVERTISSEMENT
RISQUE DE DÉCHARGE
ÉLECTRIQUE
Fixez le collier de serrage dans le trou présent seulement.
NE PERCEZ PAS dans le réfrigérateur.
ADVERTENCIA
PELIGRO DE DESCARGA
ELÉCTRICA
Adhiera la abrazadera de la tubería usando el agujero
existente únicamente. NO perfore el refrigerador.
ADVERTENCIA
PELIGRO DE DESCARGA
ELÉCTRICA
Adhiera la abrazadera de la tubería usando el agujero
existente únicamente. NO perfore el refrigerador.
