25
31-1000600 Rev. 0
STEP 7 INSERTING/SECURING
INTO CABINET SURROUND (Cont.)
Ŷ
Replace the waterline strain relief screw.
Ŷ
Store the excess string, and water tubing under
the unit.
Installation Instructions - Dual Integrated Installation
WARNING
Electrical Shock Hazard.
Replace waterline strain relief in front rail location as
shown.
Strain Relief
Screw
STEP 8 LEVEL UNIT
All models have 4-point leveling. The front is supported
by leveling legs; the rear is supported by adjustable
wheels. Both are accessible from the front of the unit.
Ŷ
To level the back of the unit, turn the 7/16” hex nut
located above the front leveling legs. Turn clockwise
to raise or counterclockwise to lower the unit.
Ŷ)RUIURQWOHYHOLQJXVHD7ELWDWWKHWRSRIWKH
leveling leg or a 7/16” open-end wrench at the bottom
of the leveling leg.
Ŷ$GMXVWKHLJKWRIXQLWWRPDWFKLQVWDOODWLRQFXWRXW
opening 84”. The unit should be level and plumb with
cabinetry.
NOTICE:
The rear leveling wheels and front leveling
legs are limited to a maximum height adjustment of 1”.
If the installation requires more than 84” height, the
installer should elevate the unit on a sheet of plywood
or runners. Cabinetry trim could also be added across
the top of the opening to shorten the opening. If you
attempt to raise the unit more than 1”, you will damage
the front leveling legs and the rear leveling wheels.
AVERTISSEMENT
Risque
d’électrocution.
Reposez la vis de décharge de
tension dans le profilé avant comme illustré.
ADVERTENCIA
Riesgo de Descarga
Eléctrica
Reemplace el amortiguador de refuerzo de
la tubería de agua frente a la ubicación del riel, como se
muestra.
T30 bit
adjusts front
leveling legs
7/16” hex nut
adjusts rear
wheels
7/16” open end
wrench adjusts
front leveling legs
