Installation Instructions - Standard Installation
20
STEP 9A INSTALL OVERLAY PANELS
• There are two sets of holes in the handle side trim.
Replace the handle side trim by installing the original
screws in the REAR screw holes.
• Secure the handle to the door using the FRONT
screw holes.
Custom Handles
If you are using custom handles, the handle must be
properly secured to the panel before sliding the panel
into the trim.
• The cabinet manufacturer will supply the custom han-
dle and hardware.
• Secure the door trim using new handle side trim.
Discard the supplied handle.
Right hand models shown. Use the same instruc-
tions for left hand models.
Install Door Panel:
• Open the door to 90°. Remove the 6 Phillips head
screws from the door handle.
• Remove the handle. Retain all screws.
• Remove the 6 screws holding the trim, lift off the trim.
Retain the screws.
• Slide the overlay panel into the door trim.
Supplied handle shown
in the overlay panel position.
Door
Door Trim
Handle
Trim
Move
Forward
For 3/4"
Panel
Use Rear Holes
to Secure Trim
Use Front Holes
to Secure Handle
