Custom Handles
•
Custom handles must be used for flush installation.
The handle must be properly secured to the overlay
panel before sliding the panel into the trim.
• The cabinet manufacturer will supply the custom handle
and hardware.
• Discard the supplied handle.
• Slide assembled door panel into the trim.
• A trim cover kit has been supplied with your refrigerator.
It contains a piece of trim for both left and right door
swing. You will only need to use one piece of trim on
the handle side of your refrigerator in place of the trim
piece you just removed. Place trim against the side of
the refrigerator door, aligned top to bottom. The holes
in the trim should align to the holes in the door. Discard
the other trim piece.
• Secure the new trim cover piece
using the retained screws.
37
Installation Instructions - Flush Installation
Use Rear Holes
to Secure Trim
Use Front Holes
to Secure Handle
STEP 9 INSTALL OVERLAY PANELS
Install door panels:
• Open door to 90°. Remove the 6 Phillips head screws
from the door handle.
• Remove the handle.
• Remove the 6 screws holding the trim, then lift off the
trim. Retain the screws.
Install 6 Handle
Side Trim Screws
Refrigerator
Door
Custom Trim
Handle Side
