Monogram ZV1050, Owner'S Manual

49-80513-5

7

CARE AND CLEANING

LIGHT BULBS

NOTE:

 The glass cover should be removed only when 

cool. 

CAUTION

Before replacing the bulb, disconnect electrical power to 

the hood at the main fuse or circuit breaker or main power 

disconnect switch located on the control housing. Allow 

bulbs to cool before touching. 
For safety, do not touch a hot bulb with bare hands or a 

damp cloth.

To change the light bulbs:

1.  Remove the lamp lens cover by inserting a small flat-

blade screwdriver into each of the three slots and gently 

prying it free.

NOTE:

 Do not remove the outer trim ring (lamp assembly).

2. Grasp the bulb and pull it straight out.
3.  Using gloves or a dry cloth, remove the new bulb from 

the packaging. (Wearing latex gloves may offer a better 

grip.) The bulb must be the same wattage, 120-volt, 

25-watt halogen with a G-9 base. Early-life bulb failure 

may occur if wattage is too high.

4.  Push the bulb straight all the way into the receptacle.
5.  Replace the lens cover by inserting the three retaining 

tabs into the slots and pressing into place.

NOTE:

 For improved lighting, clean the glass cover 

frequently using a damp cloth. This should be done when the 

hood is completely cool.
6.  Reconnect electrical power to the hood.

NOTE:

 Order replacement 120-volt, 25-watt halogen bulb 

with G-9 base, WB25X10020.
These bulbs can be ordered from your Monogram supplier.

NOTE:

 Make sure the tabs are inserted into the slots.

ONLY use a new 120-volt, 25-watt halogen bulb with a 

G-9 base.

NOTE: 

Do not touch the new halogen bulb with bare 

fingers. Skin oils can cause early-life bulb failure.

On some models, the lights are located on 

the sides, on the underside of the hood.

On some models, the lights are located on the 

front and back, on the underside of the hood.

Receptacle

Use gloves  

or cloths

Outer trim ring  

(lamp assembly) 

Do not remove

Bulb

Removable inner 

lamp lens cover

Tab

Use a small flat-blade screwdriver  

to remove the lamp lens cover.