49-80152 Rev. 8
13
Installation Instructions
7
INSTALL FILTERS
■ Drop grease tray into the hood. The rear tabs should
engage the slots in the hood track.
■ Insert the grease filter into the opening and drop into
the bottom. Raise filter to the top and lock into place.
■ To remove the filters, grasp the handle, push the filter
up and lift out.
8
INSTALL BACKGROUND AND SHELF
INSTALL BACKGUARD
■ Remove packaging.
■ Place backguard against the bottom of the hood to
use as a template. Mark upper screw locations "A"
and "B".
■ Remove backguard.
■
Drill four 1/8" pilot holes at screw locations "A" and "B".
■ If drill did not enter studs, enlarge the holes to 3/8".
■ Insert the wall anchors into the enlarged holes.
Remove screws from the wall anchors.
■ Align and secure the backguard to the wall using 2
wall anchor screws or wood screws in locations "A".
■ For 30" and 36" models, install 2 screws through hole
locations "C" at the bottom of the backguard. For 48"
models, install 4 screws.
■ If installing the backguard alone, without the shelf,
drive screws in all locations shown.
This hood can be installed with the warming shelf
and backguard together or with the warming shelf or
backguard alone.
INSTALL SHELF OVER BACKGUARD
■ Install two shoulder screws into holes "D" in the
bottom of hood flange leaving 1/8" gap.
■ Remove shelf packaging and protective film.
■ Engage shoulder screws into the keyhole slots in the top
of the shelf. Slide shelf towards the left to lock into place.
■ Install two 3/4" long machine screws through the bottom
of the shelf into the bottom hood flange, location "E".
■ Install anchor screws through the shelf and into the wall
holes "B".
■ Remove all protective film.
Mounting
Holes for
Backguard (A, C)
and Shelf (B)
C
BACKGUARD
A
A
B
B
1/8"
Gap
D
B
E
D
E
B
1” = 2.5 cm; 1’ = 0.3 m
