14
49-80152 Rev. 8
Installation Instructions
9
INSTALL SHELF "ONLY"
■ Remove shelf packaging and protective film.
■ If installing the shelf alone, without the backguard,
place shelf against the bottom of the hood and mark
the screw hole locations "B" on the wall.
■ Drill two 1/8" pilot holes.
■ If the drill did not enter the studs, enlarge holes to 3/8".
■ Insert the wall anchors into the enlarged holes.
Remove the screws from the wall anchors.
■ Install 2 shoulder screws into holes "D" in the
bottom of the hood flange leaving 1/8" gap.
■ Engage shoulder screws into the key hole slots in
the top of the shelf. Slide the shelf towards the left
to lock into place.
■ Install two 3/4" long machine screws through the
bottom of the shelf into the bottom hood flange
location "E".
10
INSTALL IMPLEMENT RODS
■ Use a flat blade screwdriver to install the stand-offs
into the bottom of the hood.
■ Align the implement rod to the stand-offs with the
screw hole towards the inside of the hood. Secure the
rod to the stand-offs with the supplied Allen wrench.
■ Follow the same procedure on the opposite side.
FINALIZE INSTALLATION
■ Install the supplied infrared bulb(s).
■ See the Owner’s Manual for instructions to test
operation.
1/8"
Gap
D
E
Mounting
Holes
for Shelf (B)
D
E
B
B
Screw
Stand-offs
Into
Hood
Use Allen
Wrench to
Secure Rod
to Stand-offs
1” = 2.5 cm; 1’ = 0.3 m
