8
49-80152 Rev. 8
Installation Preparation
REMOVE THE PACKAGING
■ Remove packages
from the "V" shaped
cardboard section.
Remove shipping pads.
■ Lift the hood out of the box.
IMPORTANT:
Lift the hood
by grasping the outside
edges of the exhaust
opening on the top.
■ The vent hood motor
is shipped secured to
the skid with 4 screws.
Locate and remove 2
screws on each side of
the motor. Discard the
shipping skid and screws.
■ Grease filters must be
removed. Grasp the
latch, pull the filter up
and lift out.
■ Lift to remove the
grease trays. Set
grease filters and trays aside
for later installation. DO NOT
DISCARD.
■ From the inside of the hood,
loosen (do not remove) the
2 screws holding the wood
mounting support to the back of
the hood. The screws should be backed out of the wood
to 1/4". Remove the set aside the mounting support with
screws for later installation. DO NOT DISCARD.
■ Remove tape and packing material from the hood and
all supplied parts.
Hood
Parts
Wood
Mounting
Support
Motor
Mounted
on Skid
Shipping Carton
Duct
Transition
PARTS PROVIDED
Locate the parts packed with the hood.
HARDWARE PACKAGE
Locate and check contents.
Screws shown actual size.
2 Stainless Steel Grease Filters
(3 filters with 48" models)
Allen Wrench
For Implement Rods
Duct Transition
with Damper
Backguard
2 Implement Rods
and 4 Stand-offs
Grease Tray
Heat Lamp
(2 with 48" models)
761Dia28
490Dia57
490Dia66
Wood Support
with Original Screws
Warming Shelf
761Dia30
2 shoulder screws
to secure shelf to
bottom of hood.
2 Phillips head
machine screws
to secure shelf to
bottom of hood.
10 Phillips head screws:
Use 6 to secure hood to
the wood support: (2 are
secured to wood support)
Use 2 to secure 30" and 36"
backguards to wall. Use 4 to
secure a 48" backguard.
4 Phillips head screws to
secure the transition to the
hood outlet on the top
6 (3/16") hollow wall
anchors with screws,
use 2 to secure
hood to the wall at
the bottom. Use 4 to
secure backguard
and shelf.
4 screws to secure the
wood support to the wall
POZIDRIV 3
1 hex head screw and
lock washer, to secure
the blower
658Dia9
2 flat washers
for wall anchors
1” = 2.5 cm; 1’ = 0.3 m
