12
49-80329 Rev. 5
Installation Instructions
1
MOUNT TEMPLATE
■ Align the template with the marks on the ceiling and
tape in place.
– Be sure the template is oriented correctly with the
front of the hood.
■ Use a plumb bob to be sure the mounting holes
will provide parallel alignment with the countertop
below.
■ Center punch all hole locations.
■ Drill pilot holes in the 4 screw locations. Use a 3/16”
bit and drill approximately 1-1/2” deep.
■ Drive 4 hex head wood screws into the center of the
ceiling joists and cross framing. Leave a 1/4” gap to
allow the screw head to engage the keyhole slots on
the support frames.
■ Cut the 8-1/2” duct opening through the sheet rock.
2
ADJUST FRAME HEIGHT
■ Measure exact ceiling height.
■ Find the exact frame height required
on the chart on page 7.
■ Remove 2 screws on each of the 4
sides of the frame to loosen the upper
structure, lower structure and blower/
motor.
■ Adjust the height “X”, according to
the chart on page 7. Use a total of
32 screws (8 screws on each side)
to secure the upper structure, lower
structure and blower/motor together.
INSTALLATION—VENTED TO THE OUTSIDE
1/4" Gap
49-80406
Printed
in
Italy
04-06
JR
36” Hood
Template
8-1/2”
Dia.
Cut a 1” Dia.
Wire Access
Hole
Cut a 1” Dia.
Wire Access
Hole
Drill 3/16”
Pilot Holes
Approx. 1-1/2”
Deep
Drill 3/16”
Pilot Holes
Approx. 1-1/2”
Deep
10-1/16” to
Centerline
of Holes
7-1/16” to
Centerline
of Holes
FRONT OF HOOD
7-1/16” to
Centerline
of Holes
24"
min.
30"
max.
36"
min.
Frame
height
2-3/4"
Ceiling
height
X
1” = 2.5 cm; 1’ = 0.3 m
