Installation Instructions
8 INSTALL FILTERS
• Remove protective film on the filters.
• Tip the filter into the slots at the rear of the opening. Lift
the filter and pull the knob forward until the filter rests on
the slots.
• Install all 3 grease filters.
• To remove the filters, grasp the knob, push the filter to-
wards the rear and tilt downwards.
• If the Clean Filter Reminder is glowing red after filters are
installed, be sure to check the left side filter is making
contact with the filter switch.
9 FINALIZE INSTALLATION
• Remove the protective film covering the control panel
on the front face of the hood, and any other packaging
materials.
• Refer to the Owner’s Manual for operating instructions.
Note:
While performing installations described in this book,
safety glasses or goggles should be worn.
For Monogram
TM
local service in your area, call
1.800.444.1845.
Note:
Product improvement is a continuing endeavor at
General Electric. Therefore, materials, appearance and
specifications are subject to change without notice.
Pub. No. 31-14900
10-10 GE
Printed in Italy
