4
31-2000734 Rev. 4
TOOLS AND MATERIALS REQUIRED
(NOT SUPPLIED)
Wire cutter/stripper
Level
Aluminized
duct tape
Safety glasses
Phillips screwdriver with
at least 6” shank
Strain relief for
junction box, 1”
diameter knockout
Electric drill with #2 Phillips
with 1/8” and 5/16” drill bits
UL listed wire nuts
Pencil and tape measure
Gloves
Installation Preparation
12" round duct
8”x12” to 12” round
duct transition
Needed for back venting only
10” round duct
PLAN THE INSTALLATION
CAUTION
To reduce risk of fire and to properly
exhaust air, be sure to duct the air outside. Do not
vent exhaust air into spaces within walls or ceilings or
into attics, crawl spaces, or garages.
PARTS SUPPLIED FOR INSTALLATION
Ŷ
1 Hardware Package
Ŷ
1 Literature Package
Ŷ
1 Installation Template
PARTS NEEDED FOR INSTALLATION
Ŷ
1 Strain Relief
Ŷ
1 Wall or Roof Cap
Ŷ
All Metal Ductwork
WARNING
PERSONAL INJURY HAZARD
Because of the weight and size of the rangehood
canopy. It is recommended that 2 people are used
to install the range hood. Failure to properly lift
rangehood could result in damage to the product or
personal injury.
NOTE:
Before making any cuts or holes for
installation, determine which venting method will be
used and carefully calculate all measurements.
REMOVE THE PACKAGING
CAUTION
Wear gloves to protect against sharp
edges.
Ŷ
Remove the hood body.
Ŷ
Remove the hardware bag, literature package and
other boxed parts.
Ŷ
Remove and properly discard the protective plastic
wrapping and other packaging materials.
Ŷ
Consider recycling options for your appliance
packaging material.
