MONOPRICE
10594 Mac User's Manual
6
7. Hardware Installation
Once the device driver has been installed and you have rebooted your Mac, you can
install the tablet.
a. Plug one end of the included USB cable into the USB port on the tablet and the
other into an available USB port on your Mac.
b. Once connected a small tablet icon will appear in the system tray.
c. Install the included AAA battery in the pen using the instructions found in section
III below.
8. Verifying Hardware and Driver Functionality
Once the software and hardware has been installed, verify the operation and
functionality of the tablet.
a. Press the power button on top of the pen. The tablet will initiate and then the LED
indicator on the left side will flash briefly.
b. Press a button on the pen. The LED indicator will flash briefly.
c. Hover the pen over the working surface of the tablet. The LED indicator will slowly
blink and the cursor on screen will move to follow the movement of the pen.
If all three tests above pass, the pen and tablet have been properly installed and setup
on your Mac.
If the tests fail, please contact Monoprice Technical Support for assistance. You can
contact Tech Support via email at
support@monoprice.com
, using the
Contact Us
form
at:
http://www.monoprice.com/home/home.asp?pn=contact
You can also use the Live Chat feature on our website, at:
https://www.monoprice.com/home/chat.asp
Tech Support is available for Live Chat during the following hours:
Monday through Friday:
6:00 am ~ 7:00 pm PT
Saturday and Sunday:
9:00 am ~ 6:00 pm PT
