7
SETUP
Warning! Take care not to remove or damage the yellow tape on the build platform. This
tape is essential to ensure the 3D model properly adheres to the build platform during
printing. If this tape becomes damaged or wears out, replace it with painter's tape,
Kapton® tape, or ordinary masking tape.
Perform the following steps to prepare the printer for use.
1.
Remove the printer from its packaging and place it on
a flat, stable surface with plenty of ventilation and a
nearby AC power outlet.
2.
Open the Accessories box and remove the Filament
Rack. Slide the tab at the flat end into the slot on the
left side of the printer frame.
3.
Ensure that the power switch on the rear panel is in the OFF position (O side
depressed). Plug the C13 end of the included AC Power Cable into the C14 panel
connector on the AC Power Adapter, then plug the other end into a nearby AC
power outlet. Depress the I side of the power switch to power the printer ON.
4.
Rotate the control wheel clockwise to move
the highlight to the Move entry, then press the
center of the control wheel to open the Move
menu.
5.
Rotate the control wheel clockwise to move
the highlight to the Home Axis entry, then
press the center of the control wheel to activate the Home Axis function. The
printer will move the extruder head to the "home" position.
6.
Turn the printer off by depressing the O side of the power switch.
7.
Slide a sheet of A4 paper between the build platform and the extruder nozzle. The
extruder height above the build platform should be 0.05mm, which is the thickness
of a sheet of A4 paper. The extruder is at the correct height when the sheet of
