19
2
Reports the connection status of all outputs. Y means
that there is a device connected to that output and N
means that there is not.
3
Reports the signal switching status.
4
Reports the HDCP compliance status of all inputs. Y
means the input AV signal has HDCP data and N
means that it does not.
5
Reports the HDCP compliance status of all outputs. Y
means that the output AV signal has HDCP data and
N means that it does not.
You can also check the current connection status of a specific output. To do so, press and
hold the ENTER button for 3 seconds to enter Inquiry Mode, then press one of the OUTPUT
buttons. For example, to see the current connection for output 2, first press and hold the
ENTER button for 3 seconds, then press the OUTPUT 2 button. The LCD screen will show
the following display and the corresponding INPUT and OUTPUT buttons will illuminate for
3 seconds.
Recall Preset
You can create and save up to nine layout presets using RS-232 commands or using the
built-in web GUI. Once saved, you can recall them using the front panel buttons.
To recall a preset, first press the RECALL button, then use the LEFT (OUTPUT 2) and RIGHT
(OUTPUT 4) buttons to select one of the presets, and finally press the ENTER button to
confirm. The LCD screen will show the following:
OUT
LINK
1 2 3 4
Y Y Y Y
OUT
IN
01 02 03 04
05 05 05 05
IN
HDCP
1 2 3 4
Y Y N N
OUT
HDCP
1 2 3 4
Y Y N N
AV
IR
01-> 02
01-> 02
PRESET LOAD:
PRESET LOAD:
PRESET 1
