22
horizontal scroll bar at the bottom of the screen to select individual layers. The
button in the lower left corner allows you to turn the projector on or off to expose the
selected layer. This can be useful for checking the positioning of the vat.
The GCode View allows you to see the GCode generated during the slicing operation. This
is intended for advanced users only.
Control Screen
The Control Screen allows you to control the motors, which lets you displace the build
plate in the Z axis, as well as control the LCD.
Use the
control at the bottom to set
the maximum movement rate (mm per minute) of the build plate in the Z axis.
The Movement Control Panel on the left side of the screen allows you to move
the build plate up or down by 50mm, 10mm, 1mm, or 0.1mm, depending on which
button is clicked. Click the Z button at the top of the control moves the build
plate to the "home" position.
The Projector Control section allows you control the
image exposed by the LCD with the following
options:
Show Calibration: A red grid is projected,
allowing you to check to see if the projector is
well-focused on the vat bottom.