4
Do not expose this device to excessively high temperatures. Do not place it in, on,
or near heat sources, such as a fireplace, stove, radiator, etc. Do not leave it in direct
sunlight.
Do not place or install this device in an area where it can be exposed to excessive
amounts of dust, humidity, oil, smoke, or combustible vapors.
Use only in a well-ventilated area. Do not use in close, confined spaces.
Prior to operation, check the unit and power cord for physical damage. Do not use if
physical damage has occurred.
Before plugging the unit into a power outlet, ensure that the outlet provides the
same type and level of power required by the device.
Unplug this device from the power source when not in use.
Take care to prevent damage to the power cord. Do not allow it to become
crimped, pinched, walked on, or become tangled with other cords. Ensure that the
power cord does not present a tripping hazard.
Never unplug the unit by pulling on the power cord. Always grasp the connector
head or adapter body.
This printer has many moving parts. Do not reach inside during printing.
For best results, the ambient/room temperature should be +59 ~ +86°F (+15 ~
+30°C) and the relative humidity should be 20 ~ 50%.
This printer should be placed away from light and should be operated in the dark.
If any resin or liquid gets into the printer, clean it out immediately.
Wear gloves, such as nitrile or neoprene when working with uncured resin. Do not
use latex gloves. If resin gets on your skin, immediately wash it off with soap and
warm water.
Wear safety glasses/goggles when working with uncured resin. If resin gets in your
eye(s), immediately flush with cold, clean water, then consult a doctor.
Clean the resin vat after printing.
Keep out of reach of children.