37
Replacing the Tape on the Build Platform
Check the surface of the tape on the build platform for wear and unevenness. If it becomes
worn, it should be replaced to ensure that the model can adhere properly to the platform.
Perform the following steps to replace the tape.
1.
Slowly remove the existing tape, taking care to remove any residue.
2.
Using the included roll of tape, carefully cover the build platform. Take care to
ensure that there are no bubbles under the tape or gaps between the strips of tape.
Optical Shaft and Screw Rod Maintenance
After about 1000 hours of use, the optical shaft and screw rod should be lubricated using
silicon grease (not included). After lubrication, run the machine through its full movement
range several times to spread the lubrication evenly.
Cleaning the Feed Gear
As the printer is used, the feed gear will gradually accumulate filament dust and debris,
which can affect its operation. Perform the following steps every 500 hours to clean the
feed gear.
1.
Ensure the printer is completely shut down.