24
Distance X/Y (mm): The distance between the support and the model surface in the
horizontal plane. The effects of this parameter are the same as the effects of the
Support Top Gap (mm) parameter.
Enable Support: Check this box to use supports.
Support Top: Determines the thickness of the top layer of the supports.
Support Bottom: Determines the thickness of the bottom layer of the supports.
Support Interface: Sets the percentage of infill used inside the supports.
Support Interface Infill Pattern: Use this drop-down menu to choose one of five infill
patterns for the supports, including Lines, Grid, Triangles, Zig Zag, and Concentric.
The pattern designs are the same as those of the infill patterns of the same name.
Build Plate Adhesion Tab
Raft Air Gap (mm): The distance between the raft and the model. This determines
the difficulty of removing the raft from the model.
Raft Extra Margin (mm): The distance between the edge of the raft and the model
surface.
Raft Base thickness (mm): Determines the thickness of the raft.