26
6.
Touch the Verify button. The printer will check the distance again.
7.
If the distance is correct, touch the OK button to proceed to the next leveling point.
If not, follow the onscreen instructions until the distance is correct and the OK
button is displayed.
8.
Continue following the onscreen instructions until all three points are properly
leveled and the Completed Screen is displayed. Touch the Finish button to
complete the leveling process.
Congratulations, you have successfully leveled the Build Plate!
MP FLASHPRINT SOFTWARE
Installation
The Guider II 3D printer uses MP FlashPrint slicing software to create print files or to print
directly from the computer via a wired USB or wireless connection. MP FlashPrint is
available for Microsoft® Windows® and Linux®, in both 32-bit and 64-bit versions, as well as
Apple® Mac® OS X®. The MP FlashPrint installation packages can be found on the included
USB stick.