49
UPDATING THE FIRMWARE
Each time you start FlashPrint, it will automatically detects and downloads the up-to-date
firmware. If an update is available, a dialog box will appear to remind you of the update.
Perform the following steps to update the firmware.
1.
Click Tools > Update firmware. You must sever any existing connection with the
printer before updating. If a connection exists, it will prompt you to cut the
connection. Click the Yes button to cut the connection.
2.
Choose the corresponding printer type and firmware version, then click OK in the
firmware update dialog. After confirming that there is no printer connection, the
software will automatically update the firmware.
3.
Reboot the Guider II printer and wait 4-5 seconds until the update progress bar is
displayed. When the update is finished, it will return to the Top Menu.
4.
Touch the Tools button, then touch About to check that the version is correct.