12
LIVE LEVELING
While printing the model, you can use this function to fine tune the gap between the
nozzle and the bed. Touch the Tune button to enter the Bed Level Correction menu, then
touch the FAR button to increase the gap between the nozzle and the bed or the CLOSE
button to decrease the gap.
Note that the Bed Level Correction value must be less than
zero.
WI-FI SETUP
You can connect the printer wirelessly to a 2.4GHz Wi-Fi® network to print models from
your Android™ or iOS® phone or tablet. Perform the following steps to setup the Wi-Fi
connection for your device.
1.
Download the free MP 3D Printer WiFi Connect app from the Google Play Store or
from iTunes, depending on which type of mobile device you have.
2.
Disconnect the USB cable from the printer. You cannot use USB and Wi-Fi
connections at the same time.
3.
Power on the printer.
4.
Start the MP 3D Printer WiFi Connect app.
5.
The SSID of your Wi-Fi network should be displayed on screen. If a different SSID is
displayed, open your device's Wi-Fi settings and select the appropriate Wi-Fi
network.
6.
Enter your wireless password.
7.
Press and hold the Move button on the Main Menu for 3 seconds. Release the
button when Smart config started is displayed on screen.
