7
SETUP
Perform the following steps to prepare the printer for use.
1.
Remove the printer from its packaging and place it on
a flat, stable surface with plenty of ventilation and a
nearby AC power outlet.
2.
Open the Accessories box and remove the Filament
Rack. Slide the tab at the flat end into the slot on the
left side of the printer frame.
3.
Ensure that the power switch on the rear panel is in
the OFF position (O side depressed). Plug the AC
Power Adapter into the power input jack on the printer. Next, plug C7 end of the
included AC Power Cable into the C8 panel connector on the AC power adapter,
then plug the other end into a nearby AC power outlet.
4.
Insert the included microSD
™
card into the slot on the right side of the printer.
5.
Turn the printer on by depressing the I side of the power switch on the rear panel.
6.
Once the printer has initialized and the home
page is displayed, touch the Preheat button to
enter the Preheat Menu.
7.
Touch the Nozzle button, then set the
temperature of the nozzle to the value
appropriate for the type of filament being
printed.
8.
Touch the Bed button, then set the
temperature of the build plate to the value
appropriate for the type of filament being
printed.
9.
Touch the Start Preheat button to start preheating the nozzle and build plate. Once
the target temperatures are reached, the button will change to Stop Preheat and
the displayed nozzle and bed temperatures should be at or near your target values.
