Rotate spools to
b
To ensure ease of installation, read the instructions
completely before installing a new paper roll. Then
follow the instructions step-by-step.
1.
Tear off excess paper at the tear-off knife.
2.
To remove cover, place thumbs on serrated
surfaces located on each side of the cover.
Pressing down with your thumbs, slide the top
cover toward the back of the calculator. Once
the cover has been pushed back approximately
1”, lift the cover off.
3.
Lift up and remove old paper roll from the
paper roll holders. Tear off paper between the
used paper roll and the printer. Pull remaining
paper through the printer by continuously
lifting the leading edge (nearest display).
4.
With the leading edge of the new paper roll,
feeding from the bottom, place the new roll
into position between the two flexible paper
roll holders.
5.
Feed the paper into the rear of the printer
mechanism until it meets resistance
(approximately 1 to 1.5 inches). Depress the
paper advance button until the paper extends
several inches beyond the printer mechanism.
Apply a firm downward
a
Rotate spools to
b
Then
f
P
Tear off paper between the
u
Pull remaining
p
Depress the
p
Apply a firm downward
a
Rotate spools to
b
Then
f
P
Once
t
Tear off paper between the
u
Pull remaining
p
Depress the
p
6.
Feed the paper through the opening of the
tear-off knife and lay top cover flat on the
calculator leaving a 1” overhang at the back
of the top cover. Apply a firm downward
and forward pressure, slide the top cover
forward until it snaps into position.
7.
Tear off any excess paper.
Changing
the Paper Tape
8
