STEP 1
Remove your new Digit segments and all components from the
box. Note that the mounting bracket and adhesive tape will be
preinstalled on each segment.
Digit segment
(front)
connector port
(4 per segment)
LED light pattern
directional
marker
mounting
bracket
damage-free
3M adhesive
(back)
connector
cables
PREP
COMPLETE SETUP
BEFORE INSTALLATION
STEP 2 (optional)
This kit includes two replacement adhesive strips, so if you want to
change your pattern to something new now that you’re adding an
add-on pack, rotate some segments on their brackets and remove
up to two other segments that might need to move.
• Attach a new strip red label side
towards the bracket with the pull
tab extending past the edge.
• Reinsert this bracket into the
removed segment.
SLOWLY
pull straight
• Hold the magnet bracket in place.
• SLOWLY pull on the removal tab,
pulling in the direction it points.
• Pull the tab straight and close to
the wall, NEVER towards you.
2
1
