Step 2
If you have a CD changer
already installed, it will need to be
disconnected now. At the changer
location, get the factory fiber optic
connector and carefully open it so you
can remove the individual fiber optic
cables. Inside, one cable will have
a red lens on the end and the other
a clear lens. Also locate the 3-wire
power connector, it will be very close
to the fiber connector.
Step 3
Open the iCruze MB1 Interface Module
package and remove the Module
and the fiber optic cable harness.
One end of the harness has a pair
of loose fibers and the other end has
the fibers joined in a single connector.
Remove the screws in the single
connector so you may separate
the two fibers from the connector.
Step 2
Open Connector
to Separate Fibers
Step 3
Remove Screws and Separate Fibers
Summary of Contents for ICRUZE INTERFACE CABLE MPC FX IM-MB1
