THE FACTORY FIBER OPTIC CABLES CAN BE IDENTIFIED
BY AN ORANGE/BROWN SEMI-RIGID INSULATION.
THE FIBER OPTIC CABLES MUST NOT BE BENT IN A RADIUS
TIGHTER THAN 1-INCH (2-INCH DIAMETER). DOING THIS WILL
PERMANENTLY DAMAGE THE CABLE.
NOTE: The Mercedes fiber optic system is configured as
a closed ring. The ring begins at the radio, goes through each
component and ends back at the radio. All connections must
be complete or the ring is broken and there will be no sound.
Light enters the factory cables through the clear lens and exits each
factory cable through the red lens. The iCruze interface cable has
clear lens on the RX cable, and a red lens on the TX cable. Proper
connection of the iCruze cable is shown in later diagrams.
iCruze must be connected in the CD changer location because
of the sequence of components required by the Mercedes fiber
optic system. Locating the iCruze in a different position on the
“chain” may cause the entire audio system to stop functioning.
Summary of Contents for ICRUZE INTERFACE CABLE MPC FX IM-MB1
