ENG
5
STEP 2
Attaching the Mount Arms to the Display
IMPORTANT!
Use extra care during this part of the installation. If possible,
avoid placing your display facedown as it may damage the viewing surface.
NOTE:
This mount comes with a selection of different screw diameters and
lengths to accommodate a wide variety of display models. Not all of the hard-
ware in the kit will be used. If you cannot nd the appropriate screw size in the kit
provided, consult the manufacturer of your display for more information.
1. Determine the correct length of screw to use by examining the back of your
display:
a) If the back of your display is at and the mounting holes are ush with the
surface, you will use the shorter screws (D or F) from the hardware kit.
b) If the back of your display is curved, has a protrusion, or if the mounting
holes are recessed, you will need to use the longer screws (E or G) and may
also need to use the spacers (I).
2. Determine the correct diameter of screw to use by carefully trying one of
each size (M6 and M8) from the hardware kit.
Do not force any of the screws – if you feel resistance stop immediately
and try a smaller diameter screw.
3. Insert the tilt adjustment rod so that it passes through both mount arms as
shown in the illustration (see Fig. 5). Attach the tilt adjustment knobs (J) using
the M4 x 10 screws (K).
Make sure the tilt adjustment knobs point down-
wards, exactly as shown in the illustration (see Fig. 5).
4. Remove the clips located near the bottom of each mount arm and take out
the pins. Open both mount arms completely as shown (see Fig. 6).
NOTE:
You may need to unlock the tilt in order to open the mount arms. Unlock
the tilt by rotating one of the tilt adjustment knobs toward the front of the mount
arm. The front of the mount arm is the side that attaches to the display.
Fig. 5
Fig. 6
Summary of Contents for MB-3105
Page 16: ...MB 3105 ...
